back
Teensy Saber Electronics V3.0
DIY Teensy based lightsaber
Download TeensySaber 3.0 KiCad files here .
What you will need:
1 x TeensySaber V3.0 PCB - because DUH
1 x SD card holder - SD1
5 x 0.1uF capacitor - C32,C33,C21,C22,C12
1 x 4.7 uH 1.2A - L1
2 x 2M resistor - R31,R32
2 x 220k resistor - R33,R34
2 x 2.2k resistor - R21,R22
1 x 6-axis IMU - U2
4 x 10uF capacitor - C31,C11,C35,C34
1 x voltage regulator - IC3
3 x FET - Q3,Q2,Q1
2 x 4 x 10k resistor array - RN1,RN2
1 x 3W digital amplifier - U1
(optional) 1-3 x auxilary FETs - These can be placed on the bottom of the board to drive additional LEDs.
Stencil - download the kicad files, export gerbers and upload to OSHStencils.
Solder paste
A reflow skillet
A test rig - if you want to test the result without soldering.
Follow this handy guide for how to put everything together. Note that the markings on the board are not great for locating where to put the components, so I recommend printing out a component map and the list above, then cross things off as you go.
Schematic:
SVG Picture created as teensysaberv2.sch.svg date 2017/08/31 21:46:21
Picture generated by Eeschema-SVG
Replaced analog 2.6W amplifier with a 3.0W digital amplifier
0.1 inch smaller
Problems? Questions? Suggestions? Check out The Crucible .
This page has been accessed 296 times since
September
27th,
2017.
Last modified:
March
29th,
2021
- Design by
Monica &
Fredrik
Hübinette